Calibrating The TS55R Blade

Five Minutes With Festool – The TS55

Let’s assume that we’ve just had a blade sharpened and we need to check the calibration between the cutting depth and the depth scale. Remember that when a blade is sharpened you invariably loose a small amount of the blade diameter. After one sharpen it may not be noticeable, but after two or three sharpens there can be a noticeable variation in your cutting depth.

 This method can also be used to fine tune the cutting depth if you’re using the saw on a different brand of guide rail, (not that I’d recommend that), as there can be a variation in the standard 5mm thickness between brands. 

To calibrate the blade on a TS55R, place the base of the saw on a piece of paper (A4 copy paper is ideal), on a  flat smooth surface and set the depth guide to zero. As we’re not on the guide rail make sure you use the unmarked indicator rather than the FS indicator.

Set To Zero
Depth Gauge set to zero. Note the blade calibration knob to the right of the FS mark.
plunged
Fully Plunged, note the plunge stop resting on the calibration knob.

Once set, gently plunge the saw down until it stops and look to see if the tips of the blade are touching the paper

Blade too high
Blade too high

Adjust by turning the calibration knob on the top of the saw until the tips of the blade just touch the piece of paper and you’re done.

Blade Set
Blade set correctly

 

 

A good habit to get into is to periodically check this to make ensure that you TS55 is working at its best at all times. 

I hope you found this “Five minutes with Festool” useful and as always your questions and comments are appreciated.

Have fun and be safe,

Cheers

Bryan

Festool, technique, training, TS55R, cool tools, blades, woodwork, power tools,

Advertisements

TS55R & CMS Module

Hi Guys

 

Todays post is all about the new CMS module for the TS55R plunge saw. For those of you who aren’t familiar with the CMS system, it is in essence a Triton workcentre on steroids.

It offers a really accurate and easy to use module for the TS55R saw, a module for the PS300, 400, and hopefully PS420, jigsaws, a linisher module and possible the most outstanding router table on the market today, the CMS-OF, which fits all of Festool’s routers. though, my personal favourite is to use it with the OF 2200.

Please watch below to see the Wood Whisper’s video review on the CMS router table.

I had fun with the CMS TS55R unit but must admit to being a bit perplexed by the lack of clear assembly instructions and the inclusion of components from the old CMS TS55 Module

Please click here, (CMS TS55R) to read my full article.

As always, your questions and comments are appreciated.

Be safe and have fun

Cheers

Bryan

The TS55R, More Info

Hi All,

I was sent this video about the new TS55-R which gives more information about the new features on the saw.
I particularly like the new riving knife, splinter guard / blade window and the new depth adjustment lever which automatically allows for the guide rail.
its been put together by the guys at intelligent workshop in the UK. Click here to view their site, its worth a look

Enjoy!!

Any comments or questions are appreciated as alwaya.

Be safe and have fun.

Cheers

Bryan

Create a free website or blog at WordPress.com.

Up ↑